In our forums, our members have been reacting to a WRXer who claims to have built the “worst fitting clubs ever.” ‘dlow206’ recounts his experience with plenty of insightful findings for where he can go better next time in a detailed post, saying:
“Here’s my story of building the worst fitting clubs ever (for me). And my findings of what a better fit is.
I am short in stature, as well as a very short wrist to floor of 30.5″. I went down a rabbit hole of wanting to try irons 1″ shorter of more than standard length. Given the shorter lengths, the swingweights would be super light unless I added back a ton of weight to the heads, but I don’t like adding an extreme amount of weight back to the heads, so I decided to compensate with heavier shafts (115 grams instead of 95). Played with this set for a while and was hitting all irons extremely poorly. Thin, fat, right, right, left. My swing didn’t deteriorate that much because I was hitting my driver well, woods well, etc.
Went back to my older set of irons, playing at standard length, and my iron play improved immediately. Since then, have been doing more testing, while paying more attention to different possible variables. What I have found is I actually prefer lighter total weight with relatively normal or slightly heavier swingweights. Did a recent fitting and found that 85 gram shafts were better for me than 95 grams with standard length and relatively standard swingweights.
Still trying to dial in a final iron shaft choice, so have a few contenders that I will be testing. Will be moving away from my current Steelfiber i95 S parallel to lighter and softer
- MMT 80 parallel R – worked pretty well in a limited number of swings at a fitting
- Fujikura Travil 85 R – the fitter liked the Axiom 95 R for me at Club Champion, but i didn’t love the effort required to swing them. If there was a 85 Axiom, that would probably have been a great fit. So i am going try a Travil 85 R which is japan only
- Steelfiber i80 CW R – i have been playing Steelfibers for a long time, so need to give one Steelfiber shaft a shot
Given I do club building work, I am going to build all of these shafts with the All-Fit universal iron adapters to pair with a Srixon 7 iron head for testing. With these adapters, there isn’t a swingweight issue because the amount of weight from drilling out is about equivalent to the universal adapter components.”
And our members have been sharing their reactions in our forum.
Here are a few posts from the thread, but make sure to check out the entire discussion and have your say at the link below.
- Mikey_HACKilroy: “That length cut costs you a fair amount in swing points. I’d posit the length mattered more than the weight because a 115g shaft isn’t going to actually add enough back after cutting an inch off. Does it mean 115 would ultimately work? Hard to say. Maybe try a 1/2″ cut and add 2g to the head to compensate assuming the 7i is 37″ long. Maybe that will feel better. It translates to the same ~D2 you’re swinging at with the 95g shafts (estimated based on common weight, but you can weigh your parts on your own obviously).”
- Stuart_G: “Your process is good – keep at it and trust it.”
Entire Thread: “I built the worst fitting clubs ever – GolfWRXers discuss”
